Holeshot Performance Products, Inc.

Bandit 1250 Undertail Inner Fender Trimming Tips

Note: These numbered photos are to be used as a helpful guide only. Feel free to call Dale after 3:30 pacific time, if you have any questions (831)-761-2808

Click the photos below for a larger view.

After reading the instruction sheet with the kit, remove the entire inner fender and trim as shown. Keep in mind that the undertail has to fit up against the inner fender when it is reinstalled back on the bike.

Be sure not to cut off the 4 mounting tabs as shown.

Test fit the undertail against the inner fender as shown.

After test fit is complete, clean up all edges of the cut plastic with hand held sander, then reinstall the inner fender on bike.

Mark and drill the two license plate bracket mounting holes, then mount up the bracket before installing the undertail. Use the original bracket bolts, washers and nuts to bolt it up. Be sure to use a few drops of blue thread lock on the mounting bolts. Solder and shrink tube all blinker and tag light wire connections.

All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.