Holeshot Performance Products, Inc.

Concours C14 Decel Popping Tips

Note: These numbered photos and instructions are to be used as a guide to when plugging the hose leading from the air box to the smog valve. Feel free to call Dale, after 3:30 pacific time, if you have any questions. (831)-761-2808

Click the photos below for a larger view.

Put the bike up on the center stand. Remove the top luggage compartment and the right side panels as shown.

This photo shows the location of the hose that needs to be plugged leading from the air box to the smog valve.

Using a pair of long needle nose pliers, remove it from the bottom of the air box, then pull and hold it out to right hand side allowing access to install the rubber plug.

Lube up the cork shaped rubber plug with Armor All and while holding the hose with needle nose pliers install, then push it 2 to 3 inches into hose. Re-install hose into the airbox, then re-assemble bike.

All orders plus shipping - Prices subject to change without notice

All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.