Holeshot Performance Products, Inc.

Jerry S (Atlanta Metro, Georgia) :

Hi Dale
"I had bought this FZ1 used and it had this Nice Holeshot System, but it was a little too loud for my taste and I like to be Under the Radar. I did not want to spend more money to replace it, just tone it down. Now with the new DB Killer from Dale Walker. It sounds a little bit subdued without loosing its throaty sound. You can hear the nice rumble without being overbearing and seems to have no effect on the power range.Of course, if I want to take it out, it can be unscrewed and removed in minutes. Thanks Dale! "

PEP :

Hi Dale,

Recently installed your DB Killer on my 1st Gen FZ1. The fit & finish of the part is outstanding (as usual for your stuff). On approaching 60k miles for the muffler, the 'bark' was getting a little more pronouced as the packing breaks down. I was looking at a rebuild or even a new slip-on to take the edge off the sound (I leave at 5 a.m. for work). This DB Killer turns out to be a very cost effective and simple solution - remove one screw and you can undo. Anyone with your muffler looking to lower the sound decibels should try your DB Killer...

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.