Holeshot Performance, Inc.

2001+ B-12 Stage 2 Jet Kit

After weeks of dyno time and road testing Dale has developed his Stage 2 Kit for the 2001+ Bandit 1200.

This kit gets big power and tons of arm stretching mid-range out of the new Bandit. Maximum drivability and smooth mid-range is still retained. It includes Dale's newly designed hard anodized needles, shims, 3 sets of original Mikuni main jets, and pilots. Two large oval K&N air filters offer maximum air flow and a crank case ventilation filter also comes in the kit.

The side panels can still be run if desired. Can you say "stealth"?!

Of course Dale includes his easy to follow instructions for the home tuner.

The kit now includes stainless allen bolts to replace the float bowl screws.

Note: It is very important to install our +5 degree timing advancer with the your new stage 2 kit. The fuel curve was calibrated with the advancer installed for the optimum results (Sold separately).

Click here for dyno charts.

2001+ B-12 Stage 2 Jet Kit
Part No. B1201-JK2 $278.00 ea.
also available without filters
(if you already own them)
Part No. B1201-JK2-NF $141.00 ea.

Our +5° timing advancer is highly recommended to complete the package when running a jet kit and a high flow exhaust system.

Better throttle response, more horsepower and torque can be expected throughout the rpm range. Detonation is not a problem with pump gas.

The Holeshot Advancer bolts on in minutes replacing the stock unit.

Now includes cover gasket.

Holeshot B-12/B-6 Timing Advancer
Part No. B-RT $53.00

Holeshot Float gauge

Click image to enlarge 		Adjusting your floats to the proper level is a very critical part of setting up your new jet kit. This high quality float gauge is what it takes to do it right. This gauge works on all types of carbs.
Holeshot Float gauge
Part No. 35-9123 $42.95

All orders plus shipping - Prices subject to change without notice

-----

[Back]

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.

Copyright (c) 1998-2010. All rights reserved.