Bandit 600/ 1200 Holeshot Petcock Rebuild Kits

Click image to enlarge

Your Bandit is getting older and the petcock fuel valve can start leaking by when the bike is sitting. This allows gas to get into the crankcase and dilute the motor oil, which can cause sever engine damage if not taken care of right away. A worn fuel valve can also lead erratic fuel delivery causing starvation to the carbs, resulting in poor running or even stall outs. The Holeshot Petcock rebuild kit is a made in japan by the same company that produced these parts for many of the OEMs. Since the super high cost of a complete new fuel valve, Dale hunted these kits down to offer to our Bandit customers. The kit contains all necessary O-rings and diaphragm to rebuild your Bandit petcock fuel valve.

Please note: These kits do not have a warranty and are non returnable

Bandit 600/ 1200 Holeshot Petcock Rebuild Kits
Bandit 600 96-03	Part No. 18-2763	$38.95
Bandit 1200 96-00	Part No. 18-2763	$38.95
Bandit 1200 01-05	Part No. 18-5023	$38.95

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.