Holeshot Performance Products, Inc.

DL-650 Slip-on Conversion installation
2007-08 models only

Note: These are a few tip photos of where to cut the pipe, heat sheild , and mid pipe install . These will be helpful along with the written instuctions you will receive with your Holeshot slip-on. Feel free to call Dale, after 3:30 pacific time, if you have any questions. (831)-761-2808

Click the photos below for a larger view.

Make a mark as shown approximently 1" past the weld bead of the header collector. Cut the muffler clear off using a metall cutting saw.

The left photo shows your header now ready to box and ship to us, via UPS for the conversion fabrication. The other photo shows the approximate mid pipe, mounting clamp and heat shield clamp location.

Install the heat shield center bolt using the provided thick flat washer and nylock nut as shown, this bolt is now for cosmetic purposes only. Install the top bolt using the provided 1/4" aluminium spacer. Install heat shield by starting the lower bolt first, loosen the top shield mounting clamp with the welded nut, to align with the top mounting bolt, then start the bolt and lightly snug. Rotate in proper position as shown, tighten upper mounting clamp, then shield mounting bolts securely.

All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.