Holeshot FZ1 4-2-1 Stainless Header System Dyno Charts

Run #006 (blue line): Dale's bone stock 06 FZ1
Run #114 (red line): Dale's 06 FZ1 with Holeshot full system and TFI tune up

Dyno room tempature for both runs was 69 degrees and 53 percent humidity

Note: These are true numbers measured on Dales in-house Dynojet 250 I Dynamometer with "Win Pep 7" program.

The Holeshot compound is about 200 feet above sea level and the dyno room stays at a constant temperature between 68-74° F. These results were also achieved with Dales tuning, which is a bonus. Dale uses his dyno as a measuring tool for development and testing only.

Be aware, that dynos, dyno operators, conditions and bikes can vary 3-8 hp, so this should only be used as a reference for before and after results.

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.