Holeshot Performance Products, Inc.

The Holeshot FZ1 timing advancer adds 3+ degrees of ignition timing. This is a very easy way to add 1 to 2+ horse power throughout the entire RPM range and pick up throttle response in the usable part of the power curve. A very smooth idle can also be expected once up to normal running temperature.

Dale's testing showed a gain of nearly 4 full ft-lbs of torque from 2500 to 3000 rpm on his Dynojet model 150 dyno. In most cases slightly better fuel economy is not uncommon with a slight ignition advance added. Pinging or heat is not a problem and although 89 octane fuel is most likely the best to run in the FZ1, Dale tested 87 octane and still could not make it ping or rattle. The advancer will not shorten engine life in any way shape or form. Testing was done on three FZ1s after Dale's Holeshot slip-on was added without jetting. Dale did it this way to independently test three different timing settings to see how the motor would react by advancing the timing only. He found the sweet spot to be 3+ degrees.

Note: Dale recommends only installing the advancer when a jet kit is added. The Holeshot advancer is included in our FZ1 Stage One Modified Jet Kit with great results. Other jet kits and tune-ups may also effect the outcome of any advancer installed, but off-idle crispness and mid-range throttle response should be enhanced without any top end loss when properly tuned to match the timing.

The Holeshot timing advancer also comes with a new cover gasket and installation instructions.

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.

Holeshot FZ1 3+ degree timing timing advancer with cover gasket
Part No. FZ1-RT	$53.00