Holeshot Performance Products, Inc.

The Holeshot FZ1 adjustable struts are precision laser cut from 1018 steel for superior strength, then powder coated in a laser black-silver metallic finish for long lasting beauty. Dale's three hole design easily allows you to raise the back 1" to sharpen up the steering for quicker turning and added ground clearance, lower the back 1.25" for shorter riders or run it at the stock ride height. They can be installed in minutes and adjusting them is done by simply removing the rear mounting bolt. The center stand and side stand will still work without a problem and do not need to be altered.

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.

Holeshot FZ1 Adjustable Struts
Part No. FZ1-AS	$68.95 per set