Holeshot Performance Products, Inc.

Stage 2 Jetting Kit Installation Tips

These photos are intended to be used as general information. Please be sure to follow Dale's complete installation instruction sheet included with your FZ1 Holeshot Stage 2 Jet Kit.
Click images to enlarge
Bend the air box mounting tab up, to allow more room when removing the air box	Once filters are installed the clutch cable can be routed on top of the left filter	Lightly nylon tie the coolant over flow hose to the frame tube and position over the right air filter
Photo of hose routings , Note! Rear breather hoses are removed from carbs , leave plastic nipples open	Remove the air box drain hoses, and lower breather hoses leading behind the counter shaft sprocket cover	Install Stainless battery tray as shown, using the original air box mounting bolts with provided stainless flat washers and nylock nuts
Route the crank case breather hose along the left frame tube, behind the left side panel. Filter should be located as shown.

All orders plus shipping - Prices subject to change without notice

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.