Holeshot FZ1 Steering Damper Kit
Installation Photo Tip Page

1

Remove left fairing panel

2

This is the damper front mounting clamp installed; position and measure per instruction sheet as shown.

3

Position the rear damper bracket as shown then measure set up per the instruction sheet.

4

Adjusting the body clamp on the damper before installing it on the bike.

5

The rear mounting point is assembled as shown. Be sure the tapered end of the spacer goes towards the damper body clamp per the instructions.

6

The front mounting point is assembled as shown. Be sure the tapered end of the spacer goes towards the rod end ball of the damper per the instructions.

7

This is what it should look like when set up and adjusted correctly.

8

This shows the fork stop contacting with the bars fully turned to the locked position as covered in step # 7 of the instruction sheet.

11

Closeup of finished installation.

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.

Copyright (c) 1998-2008. All rights reserved.