 |  |
| |
For REGULAR Bar Snake:
1. Read entire installation instructions before attempting to install your BAR SNAKE.
2. Observe all safe working practices while installing your BAR SNAKE.
3. Remove both handle bar grips.
4. Attach the pull wire (Installation Tool) through the nylon bushing of the BAR SNAKE. Approximately four inches of the wire should extend through the bushing and be securely attached by twisting the loose end around the wire four to six times.
5. Generously grease the inside end of the handlebars you will be pulling the Bar Snake through. (Note: Any lubrication grease should work.)
6. Grease the entire length of the BAR SNAKE.
7. Insert the pull wire into and all the way through the handlebars.
8. Attach the free end of the pull wire to a screwdriver or other similar object as to form a pulling handle.
9. Pull the Bar Snake into and through the handlebars leaving excess sticking out both ends of the handlebars.
10. Cut off excess length of BAR SNAKE from each end of the handlebars.
11. Reinstall grips securely to handle bars.
12. Test ride and experience the smooth vibes of your new BAR SNAKE!
For LIQUID Bar Snake:
1. Read entire installation instructions before attempting to install your BAR SNAKE.
2. Observe all safe working practices while installing your BAR SNAKE.
3. Remove one handle bar grips/bar end weight.
4. Secure handlebar in the upright position.
5. Mix 2 parts together.
6. Pour mixture into handlebar tube.
7. Let set up for one hour.
8. Reinstall grip/bar end weight securely to handlebars, and bars to the bike.
9. Let cure for four hours.
10. Test ride and experience the smooth vibes of your new BAR SNAKE!
