Holeshot Performance Products, Inc.

Holeshot FZ1 Fender Eliminator Kit
Installation photo page

Note: These numbered photos and easy to follow tips are your installation guide for the kit.

Click the photos below for a larger view.

Disconnect the blinker, tail and plate light plugs. Un-bolt rear fender, then carefully pull all wires through and remove the fender.

Be sure to review all photos before you start the installation.

This shows the fender being removed and how the 8 mm stainless button head allen bolts are to be installed in the Holeshot fender eliminator tray.

Apply a few drops of blue Loctite on the bolts then install the Holeshot fender eliminator tray.

Use the 8 mm flange nuts on top and lightly snug only at this time. Move the tray right to left and center to your liking, then tighten the nuts while holding the bolt heads with a allen wrench.

Cut the original blinker wires off at about a 6" length as shown, making note of the left and right blinker first. Neatly solder and shrink tube to the cat eye blinker wires. Crimp connectors are not recommended.

With wires shrink tubed, install the cat eye blinkers onto the stainless bracket with the bracket ears pointing forward. Install the bracket against the tray, then your license plate and frame last. Adjust up and down to your liking and snug down. Neatly route the blinkers wires through the large hole in fender eliminator tray and plug back into the bike's wiring harness. You may want to use a couple small black nylon ties to do a neat job.

To install flush mount style blinkers mark the spot with painters tape as shown and start with the right hand side. Hold blinker up in position, then mark where the blinker wire hole needs to be drilled. Using a step drill bit drill a 7/32" hole as shown.

Apply double sided foam to blinker as shown. Cut about 16" of 18 gauge wire and slightly bend the end as shown.

Neatly tape the 18 gauge wire to both blinker wires and fish through holes as shown. This little trick allows you to leave the tail section totally assembled and route the wires to the plugs.

Using a good light, fish the wire forward until you can reach it with needle nose pliers as shown.

Peel off the protective tape then carefully mount the blinker in the proper position on the tail section. Cut the original right hand blinker wires at about a 6" length as shown here and in photo 5.

Lay a towel on the bike, then solder and shrink tube the right hand blinker plug wires to the flush mount blinker wires as shown.

Neatly route the blinkers wires as shown and plug back into the bike harness. Install the left hand blinker using these same steps. Install your license plate and frame, adjust up and down to your liking then snug down.

If you need a hand feel free to give us a call and also be sure to let me know how you like your new Holeshot FZ1 rear fender eliminator kit via email.

All orders plus shipping - Prices subject to change without notice

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.