|
Big Handling Improvement / Fast turnaround timeThe V-Max swing arm flexing is the main culprit when you get a bad case of the wobbles on top end or cornering. We hand fit and tig weld chrome moly tubing to the bottom of the swing arm for superior strength. This is a big handling improvement.Swing arm comes unpainted. Retains center stand. Note: Will clear most Slip-ons and our 4 into 2 system. Does not clear stock exhaust, Kerker header, or Cobra Slash Cut slip-ons.
Don't be scared! Swing arm removal and installation
is very easy with normal hand tools.
|
||||
|
|
|||||
 Click image to enlarge |
We now offer a gloss black powder coating service after fitting your Holeshot swing arm brace.This offers a very clean look as well as a tough protective coating.
|
||||
Disclaimer
All Holeshot Performance Products are intended for closed course racing
purposes only, never to be used on any road or highway anywhere in the world.
Many of our products are illegal on pollution controlled vehicles so installing
them is at the sole discretion of the buyer. Be sure to check your local laws.
Holeshot Performance Products is not responsible for any engine damage that
may occur from improper installation of any of its products.
Holeshot Performance Products, Inc. ® is a trademark of Holeshot
Performance. Any other product names are the trademarks of their respective
holders. All rights to use this publication are exclusively owned by, and
proprietary to, Holeshot Performance Products, Inc.
No part of this publication or
web site may be reproduced or transmitted in any form or by any means,
electronic or mechanical, without first obtaining written permission from
the publisher.
Copyright (c) 1998-2008. All rights reserved.