Holeshot Performance Products, Inc.
Report an issue with this page...

Title Text

Subtitle Text
NOTE: These numbered photos are to be used as a guide in conjunction with the written instruction sheet supplied with the kit.
Be sure to review all photos before you start the installation, feel free to call Dale if you have any questions.
775-463-5394
1

Remove left fairing panel.

2

This is the damper front mounting clamp installed; position and measure per instruction sheet as shown.

3

Position the rear damper bracket as shown then measure set up per the instruction sheet.

4

Adjusting the body clamp on the damper before installing it on the bike.

5

The rear mounting point is assembled as shown. Be sure the tapered end of the spacer goes towards the damper body clamp per the instructions.

6

The front mounting point is assembled as shown. Be sure the tapered end of the spacer goes towards the rod end ball of the damper per the instructions.

7

This is what it should look like when set up and adjusted correctly.

8

This shows the fork stop contacting with the bars fully turned to the locked position as covered in step # 7 of the instruction sheet.

9

Closeup of finished installation.