Holeshot Performance Products, Inc.

Dale's trimming hand guard tip photo page

NOTE: These numbered photos are to be used as a guide in conjunction with the written instruction sheet supplied with the kit.
Be sure to review all photos before you start the installation, feel free to call Dale if you have any questions.
775-463-5394

1

Remove both hand guards to trim off mounting tab, using hand drill or drill press as shown.

2

Using a 1-1/2" hole saw, trim off the end of both hand guard's.

3

After drilling you must clean them up with sand paper, and trim the ends.

4

Trim off ends and sand smooth as shown.

5

Re-install both hand guards and let rest against the Throttlemeister bar ends, they do not have to be solidly mounted to the bar ends for normal road use.